Exhaust mount and Dash changes

The exhaust mount is now welded in place and works brilliantly with the Jetex twin exhaust.

Would have been easier to do while it was still a skate but I justunbolted the chassis and lowered the subframe and shielded the close vicinity with some old bits of ali sheet so as to avoid any weld spatter.

The final bit of work on the exhaust will be adjusting the tailpipes to clear underneath the rear of the body. That will probably mean a slight dogleg.

I wasnt really happy with the position of the three gauges pictured. The bottom of the tacho was obscured by the steering cowl.

I glassed them up then filled with P40 Chopstrand and will finish with some smooth P38.

Ihave enough vinyl left to then wrap it again.